7/64 Ceramic Pressure Nozzle Kit For Pressure Pot Blaster's (3pk)

The 7/64″ bore is not found in ALC nozzle lines - it is Allsource-specific for blasters 41001, 41002, and 41003. If your Allsource blaster specifies 7/64″, this is the correct replacement. The 3/32″ and 1/8″ sizes are not interchangeable with 7/64″ blaster housing dimensions.

The 7/64″ bore sits between 3/32″ and 1/8″. It delivers more coverage per pass than 3/32″ while drawing less air than 1/8″. For Allsource blasters that specify 7/64″, this size is the only correct replacement - the bore is matched to the blaster housing thread and seal dimensions.

Three nozzles gives two full replacement cycles before reordering. For shops running 7/64″ as their standard Allsource nozzle, buying three reduces ordering frequency and keeps the correct size in stock. Replace when the bore shows visible wear or blast output drops at standard pressure.

No. These ceramic nozzles are sized for Allsource blasters 41001, 41002, and 41003. Not compatible with ALC-brand pressure pot blasters. Thread dimensions and bore sizes are specific to each blaster brand. Always match the nozzle part number to your blaster brand and model before ordering.

Verify your Allsource blaster model is 41001, 41002, or 41003. Confirm the existing nozzle bore is 7/64″ - measure the worn nozzle or check the blaster manual. Ordering the wrong bore means the nozzle does not fit the housing or seals incorrectly, causing leakage during blasting.