High Temp Silicone Cap SC-0156X1000-L – 0.156" ID x 1.000" Length (100ct)

The SC-0156X1000-L silicone cap measures 0.156 inches in inside diameter and 1.000 inch in length, suitable for masking #10-sized threads and similar holes.

This cap is rated to 500°F (260°C), allowing it to remain in place through full powder coating cure cycles without degrading or losing its seal.

Each pack contains 100 silicone masking caps.

This silicone cap is used to mask threaded holes, studs, and precision fasteners during powder coating. Placed before spraying, it keeps powder off protected surfaces and withstands the oven cure cycle, leaving threads clean and functional after removal.

They are molded from high-temperature silicone rubber, combining flexibility for easy application with thermal resistance up to 500°F and resistance to powder coating chemicals.

Yes, silicone masking caps are designed for repeated use. Remove carefully after each cure and inspect for any damage; discard caps that have stretched out or cracked.

Yes. Contact Creative Coating Solutions via the website for volume pricing on quantities beyond the standard 100-count pack.